BrainAMP - Installation - Brain Products

Wednesday, 02 de September de 2020
BrainAMP - Installation - Brain Products

Proceed as follows if you want to use the USB interface:

1. Install the BrainVision Recorder software as described in the User Manual for the Recorder.

2. Connect the USB2 Adapter to the computer. Use only the supplied USB cable to do this.

3. The computer will inform you that a new hardware component has been detected and will then install the driver for the USB2 Adapter. Note that Windows® requires that the driver is re-installed for each USB port the first time that the USB2 Adapter is used on a different port.

4. Connect the amplifier power supply. If you are using the PowerPack as the power supply, you must charge it first. Disconnect the PowerPack from the charger before connecting it to the amplifier. The PowerPack is the only option in the MR environment.

5. Connect the amplifiers to the relevant connections on the USB2 Adapter using the supplied fiber optic cables.On the BUA64, these are the connections marked Fiberoptic 1 and Fiberoptic 2 and on the BUA128, they are the connections marked Fiberoptic 1 to Fiberoptic 4.

6. After you have connected the amplifier(s) to the USB2 Adapter, switch on the amplifier(s) using the Power switch on the back of the amplifier. The Power LED lights up on the front of the amplifier.

7. After you have connected the components to each other, start the Recorder. If the system is working correctly, the No Sync. LED located on both the USB2 Adapter and the amplifier goes off. 

If the LED lights up during the measurement, this indicates that no synchronization has been detected while data is being received and sent. There is either a problem with the fiber-optic cables or their plugs or with the sockets on the USB2 Adapter or the amplifier.

 

 

The content published here is the exclusive responsibility of the authors.

Autor: